Great Planes Evader EDF Sport Jet EP ARF - GPMA1800 - Manual (Page 6)

6
MOTOR & FAN INSTALLATION
Assemble the Stand
The included assembly/transport stand holds your Evader
upside-down or upright.
Test-fi t, then glue together the plywood parts of the stand.
The stand may be used as-is, or you could add foam tape
cut into 1/8" x 9" [3.2 x 230mm] strips. The foam will adhere
best if you fi rst sand the edges of the stand, then seal with
medium CA before applying the foam.
Prepare the HyperFlow Fan Unit
❏
1. Review steps 1 through 6 for Installing a Brushless
Motor on pages 6 and 7 of the separate HyperFlow instruction
manual, but don’t perform any of the steps yet.
❏
2. Enlarge the hole in the fan housing as shown. Once the
fan unit and motor have been installed in the fuselage, this
will allow removal of the motor without having to remove the
brass fan adapter.
❏
3. As shown in the HyperFlow manual, trim the three
alignment guides from inside the fan housing. (Also as
noted in the HyperFlow manual, a rotary tool with a sanding
drum make this easier.)
❏
4. Trim any fl ashing from around the fan housing so the
fi berglass cone adapter will fi t well.