Cadillac CTS User Manual

Page 249

Advertising
background image

To program the vehicle to a different mode, use
the following procedure:

1. Enter the personalization portion of the

SETUP menu following the instructions
listed previously.

2. Turn the TUNE/SEL knob until HORN

SOUNDS AT LOCK is highlighted.

3. Press the TUNE/SEL knob to switch back and

forth between on and off.

When the mode is turned on, a check mark
will appear next to the feature name.

If you select this feature to be on, Lights Flash At
Lock will also be on. You can choose Lights
Flash At Lock by itself, but Horn Sounds At Lock
will always have Lights Flash At Lock enabled
when it is selected.

The mode you selected is now set. You can either
exit the programming mode by following the
instructions later in this section or program the
next feature available on your vehicle.

Exterior Lights at Unlock

This feature turns on the exterior lamps when the
Remote Keyless Entry (RKE) transmitter is
used to unlock the vehicle. The lamps will remain
on for about 20 seconds unless a door is
opened, the ignition is turned to ACCESSORY,
ON, or START, or the RKE transmitter is used to
lock the vehicle.

Programmable Modes

Mode 1: ON

Mode 2: OFF

Before your vehicle was shipped from the factory,
it was programmed to Mode 1. The mode to
which the vehicle was programmed may have
been changed since it left the factory.

249

Advertising
This manual is related to the following products: