Heckler&Koch VP9 User Manual

Page 7

Advertising
background image

12

13

SECTION 5 INSTRUCTIONS FOR USE

CLEARING PROCEDURES

1. Point the muzzle of the VP9 in a safe direction.
Ensure the muzzle of the VP9 is pointed in a safe direction and that the operator’s fingers

are off the trigger and outside the trigger guard.

2. Remove the magazine.
Depress either side of the ambidextrous magazine release and remove the magazine from

the magazine well.

3. Open and lock the slide to the rear.
Grasping the charging supports, rack the slide to the rear while keeping the muzzle

pointed in a safe direction. Pivot upwards on either of the ambidextrous slide release

levers and lock the slide to the rear. Watch for a cartridge or empty case to be ejected

out through the ejection port.

4. Inspect the chamber.
Inspect the chamber for the presence of a cartridge or empty case by:

1. Visually inspecting the chamber through the open ejection port.

2. Physically inserting a finger through the ejection port and sweeping the chamber

and feed ramp area.

3. Removing any cartridges or empty cases from the chamber or from within the

VP9.

Figure 4 — Clearing the VP9 Pistol

Figure 5 Figure 6

Installing backstrap Push the grip panels forward

and grip panels into the guide rails on the frame

Installation of the Backstrap and Grip Panels

1. Using a 2.8 mm pin punch, remove the pin (clamping sleeve) holding the backstrap

in postion. Choose the combination of backstrap and grip panels that provide the most

comfortable fit for the operator (See Figure 5).

2. Install the two grooves on the inside of each grip panel onto the corresponding

tongues located on the outside of the frame (Figure 5 and Figure 6) and push the panels

forward until they seat flush into the frame.

3. Seat the backstrap on to the back of the frame and push upwards until the mounting

surface for the pin/clamping sleeve on the backstrap aligns with the mounting surface for

the pin/clamping sleeve on the frame.

4. Drift the pin/clamping sleeve into position and capture the backstrap to the frame

using the pin punch.

Advertising