HONDA 2008 Fit - Owner's Manual - Manual (Page 203)

Insert the new bulb into the hole,
and turn it one-quarter turn
clockwise to lock it in place.
Push the electrical connector back
onto the bulb. Make sure it is on
all the way.
Turn on the fog lights to test the
new bulb.
Reinstall the fog light assembly,
then tighten the screw.
Use a Phillips-head screwdriver to
remove the screw.
To remove the fog light assembly,
slide it inward, then carefully pull
it out of the bumper.
Remove the electrical connector
from the bulb by squeezing the
connector to unlock the tab, then
slide the connector off the bulb.
Remove the bulb by turning it
about one-quarter turn
counterclockwise.
1.
2.
3.
4.
5.
6.
7.
8.
Lights
200
ELECTRICAL CONNECTOR
SCREW
2008 Fit
Table Of Contents Main Menu