HONDA 2008 Fit - Owner's Manual - Manual (Page 237)

If something electrical in your
vehicle stops working, check for a
blown fuse first. Determine from the
chart on pages
and , or the
diagram on the fuse box lid, which
fuse or fuses control that device.
Check those fuses first, but check all
the fuses before deciding that a
blown fuse is the cause. Replace any
blown fuses, and check if the device
works.
Turn the ignition switch to the
LOCK (0) position. Make sure the
headlights and all other
accessories are off.
Remove the cover from the fuse
box.
Check each of the large fuses in
the under-hood fuse boxes by
looking through the top at the wire
inside. Removing these fuses
requires a Phillips-head
screwdriver. Check the smaller fuses in the
primary under-hood fuse box and
all the fuses in the interior fuse
box by pulling out each one with
the fuse puller provided in the
interior fuse box. 3. 1.
2.
4.
236 237
Fuses
Checking and Replacing Fuses
234
FUSE
BLOWN
FUSE PULLER
2008 Fit
Table Of Contents Main Menu