Clarity 440 - Manual (Page 20)

Memory Storage
20
Dialing the EMERGENCY Number
1. Unit must be in standby mode only.
2. Press the EMERGENCY key once.
3. The display will show the stored name
and number for 5 seconds. Otherwise
it will show -NO RECORDS-.
4. Then the handset goes off-hook and dial
out the stored numbers.
Or
5. Press TALK key to make handset goes
off-hook.
6. Press the EMERGENCY key once. The
display will show the stored name and
number for 1 sec. Then the numbers
will be sent out.
Deleting the EMERGENCY Number
1. Unit must be in standby mode.
2. Press the EMERGENCY key once.
3. If this key has been programmed, the
display will show the stored number.
Otherwise, it will show MEMORY EMPTY.
4. Press DEL/CH key once to delete this
number.
5. The display will flash DELETE ?.
6. Press DEL/CH to delete. The handset
will give a success keynote.
characters and numbers will replace the
original phone record.
11. The display will show NUMBER STORED.
Adding the EMERGENCY Number
1. Unit must be in standby mode only.
2. Press MODE key twice. The display will
show PHONEBOOK for 1 second and
then display the first available record.
3. Press the UP( ▲ ) or DOWN (
▼
) button
to go to the record to be stored to the
EMERGENCY key.
4. Press and hold the EMERGENCY key for
2 seconds.
5. The phone number is copied to the
EMERGENCY key. The LCD will display
MEM STORING for one (1) second and
the handset will give a success keynote.
PM080404_C440_RevB_E#34CA7F.qxd 8/14/04 15:08 Page 20