Crosley CR-78 - Manual (Page 13)

12
There is no power
1
Make sure radio is plugged in correctly.
2
Look at the STANDBY light and check to see
if it is red.
3
If the STANDBY light is not red, check the
POWER button to make sure that it is pushed
in and the main POWER is on.
4
If the red light is on, press the STANDBY button.
Pressing the STANDBY button should turn the
red light to green.
There is no sound
1
Make sure the mute function is turned off.
2
Check that the volume is turned up by pressing
VOL+ button on the control panel or on the
remote.
Note: Volume range on some units start at level
15 and ends at level 40.
3
Make sure ext./int. switch on back of radio is
on int. (unless you are using external speakers,
in which case it should be on ext.)
4
Check to make sure power is turned on.
CD does not play
1
Check to make sure CD is inserted correctly
(label side facing up).
2
Check to see that surface of CD is clean.
3
Make sure radio is on CD function by pressing
CD on the control panel.
Remote not working
1
Replace batteries.
2
Be sure to point the remote towards remote
sensor when operating.
3
Remove obstacles in the path of the remote and
the radio so the remote signal has a straight
path to the radio.
Trouble Shooting
Turntable will not work
1
Check that the radio is in phono mode.
2
Try moving the tone arm to the right until you
hear a click.
Presets will not stay programmed
1
Make sure that when you turn off the radio, you
do not press the POWER button to do so.
2
Use the STANDBY button or the POWER button
on the remote to turn the power off.
General