IC Realtime 2 Megapixel 3-9mm VF Full HD Vandal-proof IR Network Dome Camera (ICIPD2000VIR) - Manual (Page 24)

18
3 Installation
Important
 Before you complete the installation and setup, do not remove the electrostatic attraction
film on the transparent enclosure. Otherwise it may result in injury.
 After remove electrostatic attraction film, do not touch dome enclosure in case it may leave
stain.
 Before the installation, please make sure the installation surface can sustain at least 3X
weight of the bracket and the camera.
3.1 Device Installation Introduction
Please refer to Figure 3-1 for device installation space information. You can use screws (diameter is less
than 4.5mm ) to secure the device. You can see there are installation position map and installation
screws in the accessories bag for you to install the device conveniently.
Figure 3-1
3.2 Device Installation Steps
3.2.1 General Installation
The general interface is shown as in Figure 3-2.
IR Motorized Zoom Lens Series Non-IR Series IR Manual Zoom Series