Disclock_insert_2 copy – ILY DiscLock DVD/CD duplication User Manual
Page 2
Press ENT
Press , to select
Press ENT to finish setting
•
•
•
1.
Press ENT
or to set
seconds and press
ENT to confirm
2.
Press ENT
or to select
mode and press ENT
to confirm
3.
Press ENT
Press , to
select language
Press ENT to disable DiscLock
and return to the normal menu
3.
Select Source – This command will allow you to change the source drive to any one of the drive(s)
inside the unit, including the HDD (if installed). The DVD-ROM drive is the default source drive.
4.
Utility – This command contains various tools such as Pre-Scan, checking drive and controller information,
firmware revisions, etc. Please refer to the “Utility” section of this manual for details.
5.
Setup – This command contains options to configure the duplicator system. The Setup menu is truncated
when the DiscLock feature is enabled. The three functions available under the DiscLock Setup menu are
the following:
6.
Image Manager (HDD required)–This command is for the management of the hard disk drive (HDD) installed
in the duplicator, such as information and image(s) stored on the HDD. Please refer to the “Image Manager”
section of this manual for details.
Note: This feature is only available on duplicators with a HDD installed. If there is no HDD
present in the duplicator, this feature will NOT show in the menu of commands.
Note: If HDD was selected as Source, then follow the instructions on “Select Image” to select
specific image files as your reading source.
Note: Each drive will be assigned a Drive # according to the installation sequence. If there is no
HDD installed, then the Reader Drive is automatically set as Drive#1.
Note: The DiscLock feature is only available for DVD to DVD (disc-to-disc) copying. The HDD-
to-disc copying cannot support this feature as the HDD cannot be used in conjunction with the
DiscLock feature.
7.
Disable DiscLock– Disables the DiscLock feature so the copies will remain in their original state. No protection
will be implemented on the copies discs. The menu will go back to its original list of commands and settings.
Note: if there is no HDD present, this feature will be #6 instead of #7.
Auto Start Time: Set the amount of time before the duplicator will automatically start.
Note: When the DiscLock feature is enabled, the master disc plus at least one blank disc
must be placed in the duplicator accordingly before the duplicator can perform Auto Start.
Button Beep: Turns the audio signal for pressing buttons (a beeping sound) ON or OFF
Language: Selects the prefered language of the display menu. Available languages are:
English (default), Spanish, Portuguese, and Japanese.
Version 2.0