Interlogix TVD-TIR6 - Manual (Page 14)

EN 12
6. Connect a 75 ohm coaxial video cable to the
camera’s video cable, and connect a 12 VDC
(TVD-TIR6-SR(-P)) or 12 VDC/24 VAC (TVD-
TIR6-MR/HR(-P)) power supply to the power
cable.
7. Check the picture and adjust the camera
position and angle as required.
Note: When installing a TVD-TIR6-MR(-P) or TVD-
TIR6-HR(-P) camera, tilting the camera
housing past 80° may result in reflection of IR
illumination from the camera base into the lens.
This can distort or obscure the picture in night
mode.
8. Tighten the shroud screws to secure it to the
mounting bracket. Ensure that the camera
shroud is firmly attached to the bracket.
9. If necessary, use a flat blade screwdriver to
adjust the zoom first, and then the focus (see
Figure 3 on page 7).
10. Put the rubber plug into the focus and zoom
holes to prevent water and moisture getting
inside.