Interlogix TVC-7120-1 User Manual - Manual (Page 17)

TruVision TVC-7120-1 Camera User Manual 15
To delete a character in the input line, select the character so that it blinks. Then
move the cursor to CLR on the command line and press
Enter .
To position the camera ID on-screen, move the cursor to POS and press Enter.
The menu will then disappear on-screen and the camera ID will be displayed on
the monitor. Use the menu button to move the camera ID to the desired position.
Press Enter. The menu will reappear. Select
Return to return to the previous
menu.
Set the sync mode
Only cameras that support both 12 VDC and 24 VAC have line lock
synchronization.
 If 12 VDC power supply is applied, SYNC mode is internal synchronization. It
cannot be modified.
 If 24 VAC power supply is applied, you can select either internal or line lock
synchronization.
Internal synchronization is the default SYNC mode. To change the SYNC
mode to line lock mode, exit the main menu. In live view mode push the OSD
control button to the right for two seconds. Repeat the operation to switch it
back from the line lock to internal synchronization.
Select the language
Use this menu to select the OSD language.
In the Setup Menu, go to Language and select the desired language. There are
eight languages available, Chinese, English, Japanese, German, French,
Russian, Portuguese and Spanish.
Reset camera settings
Use this menu to reset the camera settings to factory default.
In the Setup Menu, go to Camera Reset and press Enter.