Interlogix TruVision Intelligent IP Dome Installation Manual - Manual (Page 22)

18 Installation Guide
To quickly put the camera into operation:
1. Prepare the mounting surface.
2 Mount the camera on the mounting surface using the
appropriate fasteners. See “Mounting the bullet camera”
on page 19.
3. Set up the camera’s network and streaming parameters
so that the camera can be controlled over the network.
For further information, please refer to the “TruVision
12/32 series IP Camera Configuration Manual”.
4. Program the camera to suit its location. For further
information, please refer to the “TruVision 12/32 series IP
Camera Configuration Manual”.
IR illuminators
The camera’s built-in IR illumination provides high-quality
video in low-light environments, even when there is no other
illumination available.
You can configure the IR illumination using a web browser or a
client software. If the function is enabled, the IR light is On
when the camera enters night (black and white) mode. If
disabled, the IR light is always Off.
The visible IR range may vary due to multiple factors, such as
weather, IR reflection rate of viewing objects, lens adjustment,
and camera settings. Please refer to the camera datasheet for
the standard IR range.
Note: Avoid installing the IR camera closely facing a tree or
wall. The reflection will cause over-exposure and lose visibility
of detail in field of view.