Interlogix TruVision IP Megapixel PTZ Installation Manual - Manual (Page 6)

6 Installation Guide
Installing a camera
Pendant-mount camera
1. Prepare the mounting surface and install the camera
bracket.
2. Unscrew the bubble from the camera and remove the
protective tape from the PTZ module.
3. Press the two tabs on either side of the PTZ module
and remove the module from the camera housing.
4. Route the cables from the pendant bracket as shown
below.
5. Attach the safety cable to the bracket and connect the
cables to the PCB of the module through the cable entry
hole on top of the housing.
R ED
AC 2 4V
YE LL OW /G R E E N
B LA CK
AC 24 V