Interlogix TruVision IP Camera Installation Guide - Manual (Page 21)

Installation Guide 21
5. Reinstall the lower dome and tighten the screws.
Mounting the wedge dome camera
To mount the wedge dome camera on a ceiling:
1. Drill the screw holes on the ceiling with the supplied
drilling template. To route the cables from the base of the
camera, cut a cable hole in the ceiling.
2. Fix the converter pan to the ceiling (optional).
Note: If required, you can remove the tabs (A) on the
side of the converter pan to pass the cables through.
3. Loosen the set screws with a hex wrench (supplied) to
remove the dome enclosure.