Interlogix TruVision IP Open Standards Dome Cameras Quick Start - Manual (Page 9)

Quick Start Guide 7 EN
Setting up the camera
Note: If the light source where the camera is installed experiences
rapid, wide variations in lighting, the camera may not operate as
intended.
For detailed instructions, please refer to the user manual.
To quickly put the camera into operation:
1. Prepare the mounting surface.
2. Connect the required cables to the camera.
3. Mount the camera to the ceiling using the appropriate fasteners.
4. Set up the camera’s network and streaming parameters so that the
camera can be controlled over the network.
5. Program the camera to suit its location.
Connecting the devices
Dome cameras:
See Figure

(Connections on the base of the dome and IR dome
cameras).
1. Ground. Connect to ground.
2. Ethernet RJ45 PoE port. Connect to network devices.
3. Audio output. Connect to an audio output. Line level, 600 Ω.
4. Initial set. Press to hard reboot camera.
5. Audio input. Connect to an audio input. 2.0 to 2.4 Vp-p, 1 kΩ.
6. RS-485 D+, D-. Connect to an RS-485 device such as a PTZ dome
camera.
7. Alarm outputs. Connect 1A/1B and 2A/2B to alarm output devices.
8. Alarm inputs. Connect IN1/GND and IN2/GND to alarm input
devices.
9. Power supply. Connect +12 VDC power supply.