Interlogix UVM-4200 - Manual (Page 11)

User Manual 9 EN
8. Memory Recall
Reset the screen to the Factory Preset Display
Settings.
 PIP
1. Multi Window
Activate or cancel the PIP function.
2. Sub Source
Select the input source the PIP screen.
(VGA/HDMI/DVI)
3. Size
Select the PIP display size
(SMALL/MIDDLE/LARGE/DOUBLE 1/DOUBLE
2)
4. Position
Adjust the PIP display position. (R-UP/R-
DOWN/L-DOWN/L-UP)
5. Border Color
Select the border color of the PIP display.
(Black/Blue)
6. Sound Swap
PIP table
SUB
Main
VGA HDMI DVI CAM1 CAM1 S-
Video
VGA X X
HDMI X X   
DVI   
CAM1    X X
CAM2    X X
S-
Video
   X X
X = Not supported

= Supported
Self-diagnosis
If there is no image, the Self-Diagnosis screen will
be displayed. The self-diagnosis function checks if
the status of the monitor screen is No Signal, Out
of range or None support.
No Signal screen is displayed
when the D- Sub signal
connector is connected but
the status of the monitor is on
DPMS mode.
Out of Range screen is
displayed when the applied
frequency is under or over
normal range.
Normal range (Non-interlaced
mode only):
H: 30 to 80 kHz
V: 56 to 77 Hz
Check that the cable screen
is displayed when the analog
signal cable is disconnected.
Removing the monitor stand
(all models)
1. Turn off the monitor and unplug the power
cable.
2. Place a cushion or a soft cloth on the floor and
put the monitor on it with the front of the monitor
facing the floor.
3. Detach the rear cover of the monitor stand with
a screwdriver.
4. Remove the six screws connecting the stand
and monitor body.
Screws (x4)