Attaching the monitor stand, Troubleshooting – Interlogix UVM-4200 User Manual

Page 12

Advertising
background image

EN 10

User Manual

Attaching the monitor stand

Tighten the screws at the locations indicated by
arrows shown in the figures above. See pictures
below.

Monitor stand attached

here

Face of monitor

stand arm

The monitor’s installation surface is compatible with
other types of VESA standard stands.

VESA mount specifications:

Model Specifications

UVM-2600

VESA standard: 100 x
100 mm and 200 x 100 mm
(3.94 x 3.94 in. and 7.87 x
3.94 in.)

Screw thread: M4 screw

Length: 8.0 mm

UVM-3200

VESA standard: 200 x
200 mm and 400 x 200 mm
(7.87 x 7.87 in. and 15.75 x
7.87 in.)

Screw thread: M5 screw

Length: 10.0 mm

UVM-4200

VESA standard: 200 x
200 mm and 400 x 200 mm
(7.87 x 7.87 in. and 15.75 x
7.87 in.)

Screw thread: M5 screw

Length: 10.0 mm

Troubleshooting

Symptom Check

Picture is jittery

Adjust

Clock

to set the

screen position and adjust
Clock value carefully until a
noise is no longer
displayed.

No picture

Check if the power switch
and computer power switch
are in the On position

Check if the signal cable is
correctly connected to the
video card.

Check if the pins of D sub-
connector are not bent.

Check if the computer is in
the power- saving mode.

POWER LED is
not lit

Check if power switch is in
the On position.

Check if the power cord is
correctly connected.

Image is unstable

Check if the signal cable is
suitable for the video card.

Image is not
centered, too small
or too large

Adjust

Clock

or

H&V

Center

to get the proper

image.

Picture bounces or
a wave pattern is
present in the
picture

Keep devices that may
cause electrical interference
away from the monitor.

See the FCC information at
the front cover of the
manual.

Picture is blurred

Adjust

Contrast

and

Brightness.

Low sound

Adjust the volume on the
OSD menu.

Adjust the volume of the
sound card in the computer.

VIDEO screen
cannot be seen

Check if PICTURE mode
has been set.

Check if the video terminal
is properly connected.

No video

Check if the video cable is
correctly connected to the
computer and set to

Functions

on the OSD

picture menu.

Advertising
This manual is related to the following products: