Interlogix DVR 60 Quick Start - Manual (Page 7)

TruVision DVR 60 Quick Start Guide 7 - EN
Figure 6: Main menu
Table 3: Main menu descriptions
Main menu
command icon Description
Display Configures display settings including dwell
time, schedule, and display formats.
Cameras Configures camera settings including motion
detection, video image adjustments, camera
title, and copy settings to other cameras.
Record Configures recording settings including
recording schedules, record quality, and record
mode.
Network Configures standard network settings including
IP address, e-mail notifications, DDNS setup,
and advanced network settings.
Alarms Configures alarm settings including alarm
input, relay output, video loss, remote alert,
prealarm and post-alarm seconds.
PTZ Configures PTZ settings.
User Configures users, passwords, and access
privileges.
Systems Configures system settings including system
date and time, audio output, device name, RS-
485 settings, RS-232 settings, firmware
upgrade, hard drive settings, boot log, and
shutdown.
Help Provides reference information to the various
toolbars, menus, and keys within the interface.
See the TruVision DVR 60 User Manual for more
information.
To enter the main menu:
Press the Menu button on the front panel when in live
mode.
To exit the main menu:
Press the Menu button on the front panel to exit the
current menu screen. Continue pressing the Menu
button until you return to the live mode screen.
Setting up IP cameras
Use the Camera Management menu to set up IP
cameras. All Interlogix IP cameras connected to the
same network are listed in the IP camera setup menu.
Note: The default IP address for Interlogix IP cameras
is 192.0.0.64. Several IP cameras could be detected
and listed that may have this same IP address.
However, each camera must have a unique IP
address in order to function correctly. Change the IP
addresses from Camera IP setup menu or from the
Web browser.
To set up IP cameras:
1. Click the Cameras icon in the main menu. On the
Camera Management screen click Setup .
2. Select the desired IP camera from the list.
3. Enter the camera parameters such as IP address
and IP camera password. The default IP camera
password is 1234.
4. Click OK to save and return to the Camera
Management screen.
It takes between 10 and 20 seconds for the new IP
camera to be listed in the Camera Management
screen. Correctly set up IP cameras have a check
mark under their Status.
Setting up alarms
To set up external alarms:
1. Connect wired alarms as shown in Figure 1 on
page 2
2. Click the Alarm icon in the main menu. In the
Alarm Management menu select the channel to
configure and click
Set .
3. Under the Alarm Input tab, select the Alarm Input
number, and click Set . The Alarm Settings screen
displays.
4. Select the alarm input type in the Input Type box.
5. Check the Rules box and click the Set button to
enter the Rules screen. Under the Associated
Cameras tab select the cameras to be triggered
for recording when an alarm is detected. Click
Apply .
6. Under the Schedule tab, define a recording
schedule for motion detection.
7. Under the Notifications tab, define the alarm
response method.
8. Click Apply and then OK button to save changes.
9. Copy the changes to another camera, if required.