Interlogix Wireless Personal Panic Device - Manual (Page 2)

2 / 4 Personal Panic Device Installation Sheet
3. Align the band so the ends of the band
are even. Cut the band in the center of
the two marks as shown below.
4. Attach the band to the clasp. Feed the
band through the retainer opening and
close the lever to lock the band in
place. Repeat for the other side.
Pendant
The Personal Panic Device can be worn as
a pendant by removing the wristband and
installing the pendant adaptor components
and lanyard in the following manner:
1. Remove the two screws on the back of
the Personal Panic Device.
2. Carefully separate the cover and base.
3. Remove the wristband.
4. Separate the components from the
pendant adaptor kit and discard the
circular center section.
5. Insert the pendant loop adapter into
the small loop end of the lanyard.
6. Insert the plugs into the base and
reattach the cover and base. Note:
Compress the panic button and base
assembly together before tightening
the screws.
Programming
Review the following information for adding
a Personal Panic Device to the panel. Refer
to the specific panel Installation Instructions
for further detail.
1. Set the panel to Program Mode.