Crimestopper Security Products CS-2004DC II - Manual (Page 13)

OPTION PROGRAMMING
You can program each option individually or multiple options in one session. You may start with the lowest option #
and continue on to higher options without repeating the steps #1 through 3.
To Engage Option Programming:
1. Turn Key to the ON position.
2. Press program / valet button 5 times, after a few seconds the unit will flash the lights 5 times and the LED will
light solid.
3. Push the valet/program button [again] the number of times that corresponds to the option number desired (1 thru
14). Press so that you get a light flash after each button press. If the unit did not flash the lights, then it did not
register your press. See chart below for option list.
4. When you reach the desired programming level, Press button #1(Lock) or #2 (Unlock) to change the option.
Pressing button 1 will provide one light flash and pressing Button 2 will provide 2 light flashes.
5. Turn Ignition OFF and check for changed features. Change each option individually repeating steps #1-5.
* =Factory Default Values
Option # Option Description Lock Button #1 Unlock Button #2
1 Auto lock with Ignition OFF *ON
2 Passive Arming ON *OFF
3 Active Re-Arm ON *OFF
4 Passive Locks ON *OFF
5 Parking Lights on w/Disarm OFF *ON
6 Brown/Black wire Function M.A.P.
(Valet Park)
*Trunk Pop
(Aux. #1)
7 Type of Carjack protection:
Active or Passive Carjack Passive *Active
8 Disarm on Trunk pop OFF *ON
9 Open Door Warning 5 Sec. *60 Sec.
10 Door Lock Pulse Time 3 Sec. *0.75 Sec.
11 Double Unlock Pulse 2 Pulses *1 Pulse
12 Enable / Disable Carjack Features Enable *Disabled
13 Starter Disable Relay Config. Normally Open *Normally Closed
14 Allow Arm/Disarm with IGN on ON OFF*
15 Option reset Reset options
13