Crimestopper Security Products CS-2004DC II - Manual (Page 22)

OPERATION
CS-2004TW1 LED TRANSCEIVER (LOW BATTERY
WARNING)
CR2032 3V
Lithium Battery
Twist and Remove
Battery cover with
a Coin or Screwdriver
Larger "+" Positive
side of battery faces up
CS2004TW1
BATTERY
REPLACEMENT
The CS-2004TW1 LED has a low battery warning
system. When the battery voltage is low, the LED
pager remote will stop beeping and flash the Orange &
Green LEDs when buttons are pressed. We
recommend replacing the battery for proper operation.
Use a small coin to twist open the battery compartment
and replace the CR2032 Lithium battery as shown in
the diagram at right.
NOTE:
Carefully insert the new battery. If done correctly the
remote will beep when the new battery installed. If the
remote does not beep or respond after replacing the
battery, remove the battery and re-insert.
22