Centro 6500 - Manual (Page 10)

8
Lighting the Side Burner
Use the Electronic Igniter on the main control panel and the Side Burner control knob, on
the far left panel, to light the side burner.
• Push in and turn the side burner control knob to the HIGH position.
• Push the igniter button.
• If the burner does not light, turn the control knob to the
OFF position and wait 5 minutes for the gas to clear.
• Repeat the above instructions. If the side burner still does not light,
refer to the troubleshooting section for help or light the burner manually.
Note: The side burner is designed to accept a maximum weight of 20 lb. Do not overload
the side burner.
Lighting the Side Burner with a Match
• Place match in front ring of provided match holder.
• Place a lighted match through the hole to within 16 cm (1/2˝ ) of the side burner.
• Push in and turn the burner knob to the “HIGH” position. At this point,
the burner should light, if it doesn’t after 5 seconds, turn the
control knob back to the “OFF” position and wait for the gas to clear.
• Wait 5 minutes, and then repeat the manual lighting procedure. If after three
tries the burner still does not light, review the troubleshooting guide for help.
Shutting Down the Barbecue After Use
• Turn off the gas cylinder valve.
• Turn the burner control valve to the “OFF” position.
This sequence is important as it prevents residual gas from being left in the system under
pressure and will make the next use easier.
Visually Check Burner Flame
Take off the grates and flame tamers. Light burners. Adjust the flame by turning the knobs
from “HIGH” to “LOW”. The flames will be smaller when the knobs are in the “LOW” posi-
tion. Always check flame prior to each use. Perform flame check for side burner.
H I
LOW