Warning – Cub Cadet SERIES 3000 GT 3200 User Manual

Page 14

Advertising
background image

14

D. Parking Brake Lever

Figure 6

The parking brake lever is located to
the right of the steering wheel in the
dash panel. With the brake pedal
depressed fully, push the parking
brake lever downward and release the
brake pedal to lock the parking brake.

E. PTO Switch
The PTO switch is located on the
lower/right side the dash panel. Pull
the knob outward to engage the PTO
clutch. Push the knob inward to
disengage the PTO clutch.

F. Brake Pedal

Figure 7

The brake pedal is located at the front
of the right running board above the
forward and reverse pedals. Depress
to stop the tractor and disengage the
cruise control. Fully depress the brake
pedal to activate the safety interlock
switch when starting the tractor.

G. Reverse Pedal

Figure 8

WARNING:

Always look

down and behind before and
while backing. Do not oper-
ate the tractor when children
or others are around. Stop
the tractor immediately if
someone enters the area.

The reverse control pedal is located
below the brake pedal. Depress the
pedal to move in reverse.

H. Forward Pedal

Figure 9

The forward control pedal is located
on the right running board below the
brake pedal. Slowly press down on the
pedal to start moving forward. The
forward ground speed of the tractor is
directly affected by the distance the
pedal is depressed.

I.

12V Power Outlet

The 12V power outlet is located on the
front/right surface of the fender, below
the seat. It is used for the convenience
of plugging in accessories that require
a power source with a maximum load
of 5 amps at 12 volts.

J. Seat Adjustment Lever
The seat adjustment lever is located
below the seat. This lever is used to
adjust the seat forward or backward.

K. Transmission Release Rod
The transmission release rod is
located at the back of the tractor in the
draw bar. This rod, when engaged,
allows the tractor to be pushed short
distances by hand.

To disengage the transmission, pull
back on the rod until its locking flange
is visible outside the drawbar, then
lower the rod into the slot and release.
To reengage the transmission, pull
back on the rod, lift out of the slot and
release.

L. Transmission Oil Fill/Dipstick
The transmission oil fill/dipstick is
located at the back of the tractor in the
rear draw bar. The handle of the
transmission oil dipstick serves as
the fill tube plug and should fit snugly
in the fill tube.

Advertising
This manual is related to the following products: