Compatible Systems 10/100 - Manual (Page 13)

Chapter 4 - LED Patterns 10
Chapter 4 - LED Patterns
Some of the LEDs on the front of the IntraPort Carrier VPN Access Server serve dual func-
tions. In addition to indicating certain server-wide operating conditions, they may also display
port-specific information.
v Note: Any continuous flashing pattern not noted in this chapter may be caused by a hard-
ware failure. Please call Compatible Systems Technical Support if your server shows a hard-
ware failure.
Server LED Patterns
Over Temp
The server is above the proper operating temperature. The filter needs changing. See the
appendices in the IPC Chassis manual for instructions.
Sys Ready
The server booted properly without detecting any failures.
General Indicators
Ethernet Traffic Indicators
TX: Ethernet transmit packet
RX: Ethernet receive packet
Load % Indicators
These lights indicate the load on the DES card.
Ethernet Lights Load Lights Indication
5 flashing 20 flashing Server stacks starting up.
3&4 flashing 40&60 flashing No OS loaded. Running from ROM.
1&4 flashing 40&100 flashing Erasing OS in Flash ROM.
5 flashing 20,40&60 flashing Erasing config in Flash ROM.
Scanning from the outside toward the center Flash ROM erase due to switch setting five or six is
complete. Set switch to zero and cycle power.