ClearSounds CSC600 - Manual (Page 6)

6 – ENGLISH
NOTE: Disposing of used batteries improperly may cause en-
vironmental damage.
PHONE MOUNTING INSTALLATIONS
The telephone may be placed on a shelf or table, or may be fixed to
a wall using the mounting bracket.
Plug the AC Adapter into the AC power back on the back of your
phone, then into an electrical outlet or surge protector, if you are
using one.
NOTE: The adapter is required for the telephone to work correctly. If
the adapter is accidentally unplugged (or in case of power failure)
the amplification feature will not work properly. If the batteries are
dead or not installed, some of the phone features will not work.
IMPORTANT: Please remove the clear plastic Caller ID tab. This film
tab is only for display and to protect your Caller ID display during
shipping.
Desk / Table Use
1 Connect one end of the 6ft telephone cord to the line jack on the back of
your CSC600 Phone and connect the other end to a modular phone jack
(RJ11C).
2 Connect the handset coil cord (curly cord) to the handset and to the
telephone.
3 Lift the handset and listen for a dial tone. If you hear a dial tone, your
phone is ready to use. If there is no dial tone, check all your cords to
make sure they are plugged in securely.
Wall Mount Use
1 Slide the handset hanger tab out and reverse its position (rotate it 180
degrees). Slide it back into place so that the hook points up. This will
keep the handset from falling out of the cradle when it is mounted on
the wall.
2 Plug the 8in short phone cord into the telephone jack on the CSC600, run
phone cord underneath wall plate adapter and through the opening.
3 Insert the Wall Plate adapter. Hold the wall plate adapter so that the raised
mounting pins line up with the phone’s keyholes on the CSC600. Once the
holes are lined up, push the wall plate adapter in towards the CSC600 and
then slide the plate upwards until it is securely seated on the phone.
4 With the Wall Plate adapter installed, plug the 8 inch short cord into the
jack on the wall.
5 Holding the phone slightly above the mounting screws on the wall jack,
push the phone against the mounting screws so they are hooked into