Hyundai H-CSX8A - Manual (Page 3)

3
Notes:
Verify that mounting location is safe for drilling and wiring, and it will not interfere with the mechanical
and electrical components of the vehicle.
Mount the unit using the brackets too the vehicle body so it does not move with sudden braking.
For underseat install, make sure it does not obstruct seat mobility
Do not expose to excessive heat and humidity.
Do not allow liquid and small objects get inside the unit.
Connecting
Follow all mounting and wiring instructions to ensure the integrity of existing wiring after installation.
Before connecting: Disconnect the vehicle's battery before making connection to the +12 volt supply wiring.
Separate audio and power wiring to avoid interference.
All wires and connections must be insulated with electrical tape, and filter with protective connector shields where ever possible.
Before replacing blown fuse check and verify that there is no short cut at all connections. Only use 15 A fuse.
A. Power input terminal connecting
Power connecting scheme see on the pic. 3.
4/8 GAUGE wire is recommended for both the power and ground connecting. 12 Gauge
- for the remote turn-on connecting. Both types are available at most Mobile Audio
Dealers or Installation Shops.
(1) Ground: to vehicle's chassis.
To avoid unwanted ignition noise caused by ground loops, it is essential that the
Amplifier be grounded to a clean, bare, metal surface of the vehicle's Chassis.
Pic. 3