Hyundai H-CSX8A - Manual (Page 4)

4
(2) +12 Volt (fused) Constant Power: To Battery (+) made directly to the positive (+) terminal of battery. For safety measures, install an in-line
Fuse Holder (not supplied] as close to the battery positive (-] terminal as possible with an ampere rating, nol to exceed total value of fuses in AMP,
(3) Remote Turn-on Input: To Power Antenna output of Car Stereo. This Amplifier is turned "ON" remotely when the vehicle's stereo is turned
"ON",
Note: If your radio does not have a +12 volt output lead when the radio is turned on, the "remote" terminal on the amplifier can be connected to
vehicle's accessory circuit that is live when the key is "on".
B. Fuse connecting
Fuse connecting scheme see on the pic. 4.
The amplifier is equipped with a plug-in auto fuse protecting set against fault conditions. Do not use a fuse
with a higher value and never bridge the fuse over. The fuse of the underside is spare fuse, if AMP not
switching on, check the upside fuse that if it is broken, if it is broken, you can put "spare fuse" insert to the
upside fuse holder.
C. Low level input connecting
Use a pair of shielded stereo audio cable with RCA type jack connect your receiver's "LINE OUT" to the RCA input.
D. High level input connecting
Connecting scheme see on the pic. 5.
Note: Inputs may be high level (from the receiver's speaker) or low level (from special low level outputs). Low level is
preferred for best performance. Use only the low level or high level input, do not use both at one time.
E. Remote control connecting
Connecting scheme see on the pic. 6.
Pic. 4
Pic. 5
Pic. 6