Connect Tech 104 - Manual (Page 12)

Connect Tech FreeForm/PCI-104 User Manual
Revision 0.00 12
Hardware Installation
Before installing the FreeForm/PCI-104 into a PC/104 stack, ensure the following:
o Slot selection properly set using the rotary switch RSW1 . Note that the FreeForm/PCI-104
address space consumes 32 bytes.
o FPGA configuration jumper J1 is set to read from Flash
Once installed in the system and power is applied, the LED D1 will illuminate to indicate that
FreeForm/PCI-104 is functioning properly.
Standalone Operation
Operating the FreeForm/PCI-104 outside of a PCI-104 stack or a PCI system for extended periods of
time is not recommended. The PCI to local bus bridge (PLX 9056) requires the pull-up / pull-down
resistors provided on a system main board.
Configuring / programming the FreeForm/PCI-104 in standalone mode is acceptable, providing it is not
left powered in that state.
Software Installation
FPGA Development Environment
FreeForm/PCI-104 has been developed with Xilinx WebPACK 9.2, available free of charge at:
http://www.xilinx.com/ise/logic_design_prod/webpack.htm
Drivers and Application Examples
The FreeForm/PCI-104 ships with a CD containing drivers for various operating systems and example
programs to help quickly develop applications. Refer to the CD for installation instructions. For other
operating systems, please check the Connect Tech website’s download zone:
http://www.connecttech.com/asp/Support/DownloadZone.asp