Intex 20 FT X 12 FT X 48 IN OVAL FRAME POOL - Manual (Page 13)

88PO
SAVE THESE INSTRUCTIONS
Page 13
(88PO) OVAL FRAME POOL ENGLISH 7.5” X 10.3” PANTONE 295U 10/09/2011
English
SS
EE
TT
UU
PP
II
NN
SS
TT
RR
UU
CC
TT
IIOO
NN
SS
POOL SETUP (continued)
7. Pull the bottoms of the side supports out away from
the liner to make the straps taut. Repeat for all
locations (see drawing 6).
8. If the ground is not concrete (asphalt, lawn or earth)
you must place a piece of pressure-treated wood,
size 15” x 15” x 1.2”, under each leg and flush with
the ground. The U-shaped side supports must be
placed in the center of the pressure-treated wood
and with the wood grain perpendicular to the support
leg (see drawing 7).
9. Flip the top ring out to ensure the top ring is fully outside of the wall line and facing up.
Inflate the top ring, keeping it centered in the middle of the pool, with an air pump.
IMPORTANT: To prevent bursting, DO NOT use a high pressure pump such as an air
compressor. DO NOT over inflate. Use an Intex manual inflation hand pump (not
included).
6
8
7
IMPORTANT
Proper inflation of the top ring.
The ambient temperatures of air and water have an effect on the top ring internal
pressure. The best procedure for maintaining proper inflation is to leave some room
for daytime expansion as the sun heats the air inside the ring. During very hot
weather check the ring to see if some air must be released to avoid damage.
In no event shall Intex, their authorized agents or employees be liable for
damages (such as pin holes) to the inflatable top ring caused by negligence,
ordinary wear and tear, abuse and carelessness, or external forces.