Ss tt oo rr aa gg ee, Save these instructions, Caution – Intex 20 FT X 12 FT X 48 IN OVAL FRAME POOL User Manual

Page 16

Advertising
background image

88PO

SAVE THESE INSTRUCTIONS

Page 16

(88PO) OVAL FRAME POOL ENGLISH 7.5” X 10.3” PANTONE 295U 10/09/2011

English

SS

TT

OO

RR

AA

GG

EE

POOL MAINTENANCE & DRAINAGE

Do not add chemicals if the pool is occupied. This can cause skin or eye irritation.
Concentrated chlorine solutions can damage the pool liner. In no event is Intex Recreation
Corp., Intex Development Co. Ltd., their related companies, authorized agents and service
centers, retailers or employees liable to the buyer or any other party for the costs
associated with the loss of pool water, chemicals or water damage. Keep spare filter
cartridges on hand. Replace cartridges every two weeks. We recommend the use of a
Krystal Clear™ Intex Filter Pump with all of our above-ground-pools. To purchase an
Intex Filter Pump or other accessories see your local retailer, visit our website or call
the Intex Consumer Services Department at the number below and have your Visa or
Mastercard ready.

www.intexcorp.com

1-800-234-6839

Consumer Service 8:30 am to 5:00 pm PT (Mon.-Fri.)

CAUTION

ALWAYS FOLLOW THE CHEMICAL MANUFACTURER'S
DIRECTIONS, AND THE HEALTH AND HAZARD WARNINGS.

EXCESSIVE RAIN: To avoid damage to the pool and over filling, immediately drain rain water that
causes the water level to be higher than the maximum.

How to Drain Your Pool and Long Term Storage

Note: This pool has drain valves installed in 2 corners. Connect the garden hose to the corner
valve that directs the water to the appropriate location.
1
.

Check local regulations for specific directions regarding disposal of swimming pool water.

2.

Check to make sure that the drain plug inside the pool is plugged in place.

3.

Remove the cap from the drain valve on the outside pool wall.

4.

Attach the female end of the garden hose to the drain connector.

5.

Place the other end of the hose in an area where the water can be safely drained away from the
house.

6.

Attach the drain connector to the drain valve. NOTE: The drain connector will push the drain
plug open inside the pool and water will start to drain immediately.

7.

When the water stops draining, start lifting the pool from the side opposite the drain, leading any
remaining water to the drain and emptying the pool completely.

8.

Disconnect hose and adapter when finished.

9.

Re-insert drain plug in drain valve on inside of pool for storage.

10. Replace drain cap on outside of pool.
11. Reverse the set up instructions to disassemble the pool. Completely deflate the top ring, and

remove all plumbing parts.

12. Be sure that the pool and all parts are completely dry before folding. Let it lie in the sun for an hour

(see drawing 8). Sprinkle some talcum powder to prevent the vinyl from sticking together and to
absorb any moisture you may have missed.

13. Create rectangular shape. Starting at one side, fold one-sixth of liner in on itself twice. Do the same

on the opposite side (see drawings 9.1 & 9.2).

14. Once you have created two opposing folded sides, simply fold one over the other like closing a book

(see drawings 10.1 & 10.2).

15. Fold the two long ends to the middle (see drawing 11).
16. Fold one over the other like closing a book and finally compact the liner (see drawing 12).
17. Store the liner and accessories in a dry, temperature controlled, between 32 degrees Fahrenheit

(0 degrees Celsius) and 104 degrees Fahrenheit (40 degrees Celsius), storage location.

18. The original packing can be used for storage.

10.1

8

9.1

9.2

10.2

11

12

Advertising
This manual is related to the following products: