Intex 18 FT X 9 FT X 52 IN ULTRA FRAME RECTANGULAR POOL - Manual (Page 13)

119
PO
SAVE THESE INSTRUCTIONS
Page 13
(119PO) RECTANGULAR ULTRA FRAME POOL ENGLISH 7.5” X 10.3” PANTONE 295U 10/18/2011
English
SS
TT
OO
RR
AA
GG
EE
POOL MAINTENANCE & DRAINAGE
Do not add chemicals if the pool is occupied. This can cause skin or eye irritation.
Concentrated chlorine solutions can damage the pool liner. In no event is Intex Recreation
Corp., Intex Development Co. Ltd., their related companies, authorized agents and service
centers, retailers or employees be liable to the buyer or any other party for costs associated
with the loss of pool water, chemicals or water damage. Keep spare filter cartridges on
hand. Replace cartridges every two weeks. We recommend the use of a Krystal
Clear™ Intex Filter Pump with all of our above-ground-pools. To purchase an Intex
Filter Pump or other accessories see your local retailer, visit our website or call the
Intex Consumer Services Department at the number below and have your Visa or
Mastercard ready.
www.intexcorp.com
1-800-234-6839
Consumer Service 8:30 am to 5:00 pm PT (Mon.-Fri.)
CAUTION ALWAYS FOLLOW THE CHEMICAL MANUFACTURER'S
DIRECTIONS, AND THE HEALTH AND HAZARD WARNINGS.
EXCESSIVE RAIN: To avoid damage to the pool and over filling, immediately drain rain water that
causes the water level to be higher than the maximum.
How to Drain Your Pool and Long Term Storage
NOTE: This pool has drain valves installed in 2 corners. Connect the garden hose to the corner valve
that directs the water to the appropriate location.
1.
Check local regulations for specific directions regarding disposal of swimming pool water.
2. Check to make sure that the drain plug inside the pool is plugged in place.
3. Remove the cap from the drain valve on the outside pool wall.
4. Attach the female end of the garden hose to the drain connector (16).
5. Place the other end of the hose in an area where the water can be safely drained away from the
house and other nearby structures.
6. Attach the drain connector to the drain valve. NOTE: The drain connector will push the drain plug
open inside the pool and water will start to drain immediately.
7. When the water stops draining, start lifting the pool from the side opposite the drain, leading any
remaining water to the drain and emptying the pool completely.
8. Disconnect hose and adapter when finished.
9. Re-insert drain plug in drain valve on inside of pool for storage.
10. Replace drain cap on outside of pool.
11. Reverse the set up instructions to disassemble the pool, and remove all connecting parts.
12. Be sure that the pool and all parts are completely dry before storage. Air dry the liner in the sun for
an hour before folding (see drawing 11). Sprinkle some talcum powder to prevent vinyl from sticking
together and to absorb any residual moisture.
13. Create rectangular shape. Starting at one side, fold one-sixth of liner in on itself twice. Do the same
on the opposite side (see drawings 12.1 & 12.2).
14. Once you have created two opposing folded sides, simply fold one over the other like closing a book
(see drawings 13.1 & 13.2).
15. Fold the two long ends to the middle (see drawing 14).
16. Fold one over the other like closing a book and finally compact the liner (see drawing 15).
17. Store the liner and accessories in a dry, temperature controlled, between 32 degrees Fahrenheit
(0 degrees Celsius) and 104 degrees Fahrenheit (40 degrees Celsius), storage location.
18. The original packing can be used for storage.
13.1
11 12.1 12.2
13.2 14 15