Intex 18 FT X 9 FT X 52 IN ULTRA FRAME RECTANGULAR POOL - Manual (Page 8)

119
PO
SAVE THESE INSTRUCTIONS
Page 8
(119PO) RECTANGULAR ULTRA FRAME POOL ENGLISH 7.5” X 10.3” PANTONE 295U 10/18/2011
English
SS
EE
TT
UU
PP
II
NN
SS
TT
RR
UU
CC
TT
IIOO
NN
SS
POOL SETUP (continued)
You may have purchased this pool with the Intex Krystal Clear™ filter pump.
The pump has its own separate set of installation instructions. First
assemble your pool unit and then set up the filter pump.
Estimated assembly time 60~90 minutes. (Note the assembly time is only
approximate and individual assembly experience may vary.)
• Find a flat, level location that is free and clear of stones, branches or other sharp objects
that may puncture the pool liner or cause injury.
• Open the carton containing the liner, joints, legs, etc., very carefully as this carton can
be used to store the pool during the winter months or when not in use.
• Remove the ground cloth (14) from carton. Spread it out completely with its edges
being at least 5 - 6’ (1.5 - 2.0 m) from any obstacle such as walls, fences, trees, etc.
Remove the liner (15) from carton and spread it out over the ground cloth with the
drain valve towards the draining area. Place the drain valve away from the house.
Open it up to warm it in the sun. This
warming will make installation easier.
Make sure the liner is centered atop
the ground cloth. Be sure to face the
end with the 2 hose connectors
towards the electrical power source.
IMPORTANT: Do not drag the liner
across the ground as this can
cause liner damage and pool leakage
(see drawing 1).
• During the set-up of this pool liner point the hose connections or openings in the
direction of the electric power source. The outer edge of the assembled pool is to be
within reach of the electrical connection for the optional filterpump.
2. Remove all the parts from the
carton(s) and place them on the
ground in the location where they are
to be assembled. Check the parts
listing and be sure all the pieces to be
assembled are accounted for (see
drawings 2.1, 2.2 & 2.3).
IMPORTANT: Do not start assembly
if any pieces are missing. For
replacement pieces call the
Consumer Service telephone
number in your area.
After all pieces are accounted for
move the pieces away from the liner
for of installation.
ELECTRICAL SOURCE
LINER
5 - 6' (1.5 - 2.0 m)
5 - 6'
(1.5 - 2.0 m)
5 - 6'
(1.5 - 2.0 m)
1
2.1
15’ X 9’ / 18’ X 9’
(A)
CORNER JOINT
CORNER JOINT
CORNER JOINT
CORNER JOINT
(F)
(D) (F)
(D)
(C)
(A) (C)
LINER
(B) (B)
(B) (B)
2.2
(A)
CORNER
JOINT
CORNER
JOINT
CORNER
JOINT
CORNER
JOINT
(F)
(D)
(E)
(D)
(F)
(E)
(C)
LINER
(B) (B) (B) (B)
(C) (A) (B) (B) (B) (B)
24’ X 12’