Cambridge Audio SONATA AR30 - Manual (Page 16)

16
Operating instructions
After making the connections to your unit, activate the Sonata AR30/DR30 by
switching the power button on the rear panel to 'On', then press the Standby/On button
on the front of the unit or remote.
Changing DAB region (DR30 only)
The DR30 has been pre-configured with a DAB region ‘EUROPE’ as the default setting.
However, the DAB can be set to a different region depending on your location. To
change the current DAB region, do the following:
Note: Make sure that the unit is turned off from the back Power switch.
1. Hold the Band button while powering the unit up. The DAB current region will be
displayed when the unit powered up.
2. Pressing the Band button will toggle between CANADA, KOREA, EUROPE.
3. Choose the correct DAB region by pressing the Select/Mode button. The unit will
then go to Standby mode and ready to be used.
Note: Always perform a complete DAB station scan every time a new DAB region has
been selected. For more information on complete DAB station scanning, see later
section ‘Tuning/Listening’.
Setting the source
Press the Source button on the front of the unit until the display indicates that the
required input is selected. Alternatively, you may select the desired input directly by
pressing the appropriate button on the remote control.
DAB aerial
The Sonata DR30 has an F-type screw connection aerial for both FM and DAB signals.
Connect the supplied combined DAB/FM aerial to the socket. For continued use, we
strongly recommend an external aerial. This should be a combined DAB/FM type or
separate aerials diplexed onto a single co-axial cable run.
Aerials (continued)
Designed and engineered in London, England Sonata DR30 Stereo Receiver
CD DVD Aux
In
Out Rec Out Sub Audio In
R
L
R
L
DD30 Dock
DAB/FM
Aerial Input
50/75
Ω F-Type
CD DVD AUX
Trigger Out
On Off
Loudspeaker Terminals
Right Left
Power AC
Power
DAB/FM aerial or external
(preferred) aerial