Cambridge Audio SONATA AR30 - Manual (Page 17)

17
AR30
DR30
ENGLISH
Adjusting the volume
Use either the Volume Up/Down buttons on the remote control, or the Volume control
on the front of your Sonata system to change the volume level. The newly selected
level will be indicated briefly on the front display.
Adjusting the audio settings
Adjustments to the bass, treble, balance and sub level can be made as follows:
1. To enter the audio menu. Briefly press either the Volume control on the front of the
unit or press and hold the Menu button on the remote control.
2. Step through the available settings by either pressing the Volume control or the
Menu button on the remote. Adjustments for bass, treble, balance and sub level
are possible.
3. When you wish to make an adjustment, simply rotate the Volume control or use the
Volume control buttons on the remote control.
4. To exit, press the Select button or wait for five seconds, until the unit returns to
normal mode.
The sub level control adjust the relative level of the subwoofer output and main stereo
outputs and can be used to control the sub level for late night listening etc.
Tuning and listening
Select the Tuner source using the Source button on the front of the unit or direct Tuner
button on the remote.
Note: Before tuning your Sonata AR30/DR30, make sure that the stereo receiver is set
to 'Manual mode'. Press the Select/Mode button on the front of the unit to select the
correct mode.
Sonata AR30
1. In tuner mode press the Band button to toggle between AM/FM modes (and SIRIUS
if an optional SIRIUS–Ready module is attached, US version only).
2. Press and hold the button to scan to previous available stations or press and
hold the button to scan to the next available stations. 'SCANNING' will be
displayed while scanning for available stations as shown below.
3. Short press once the or button to fine-tune station frequency.