Intex PURESPA 77" BUBBLE MASSAGE SPA 2014 - Manual (Page 10)

254
PO
S AVE THESE INSTRUCTIONS
(254PO) SPA ENGLISH 7.5” X 10.3” PANTONE 295U 10/18/2013
English
Page 10
SET UP
(continued)
Spa Control Unit Installation
1. Connect the spa control unit to the spa tub (see drawing 10). Hand-tighten the connectors securely.
Do not use tools to tighten.
2. Reinstall the back cover (2) to the spa control base (see drawing 11).
CAUTION: Back cover must be installed before using the SPA. Do not sit, lean, cover or place
any objects over the spa control unit.
3. Attach the two fi lter cartridge housing assemblies to the two outlet
grids on the inside of the spa (lower position, marked “C”).
ATTENTION! In order to comply with the requirements of the
Virginia Grahame Baker Act, suction outlets cannot be covered
while the spa is in use. The Act was intended to address high
suction / volume circulation systems but does not exclude low
volume systems as used on this spa. Accordingly, remove the fi lter
cartridge assemblies and any other spa cleaning attachment from
the spa outlets before spa usage (see drawing 12).
Re-attach them after usage for water fi ltration and cleaning.
4. Before fi lling with water ensure the bottom drain valve caps are
securely closed on the inside and outside.
5. Fill the spa tub with freshwater to a level between MIN and MAX
marked on the inside of the spa wall. Do not over fi ll the spa.
. WARNING: Never pour water with a temperature higher than 104°F (40°C) into the spa directly. It is
recommended to fi ll the spa tub with lukewarm water for quick heating and energy saving.
6. Place the spa cover and spa air bladder (pre-installed in spa cover) over the spa tub, and make sure the
spa cover buckles are locked using the key provided after pulling the buckled straps tight.
IMPORTANT: Inspect the spa cover regularly for leak, premature wear and tear or deterioration. Never
use a damaged spa cover.
7. Ensure the spa is plugged into a grounded electrical socket and press the button to turn on the
control unit panel buttons fi rst. Press the button on the control panel to activate the heater, see “Spa
Control Unit Panel” operation section. The heating system is capable of increasing the water
temperature by approximately 2-3ºF (1-1.5ºC) per hour.
12
C
11
2
10