Juniper Systems Allegro Top Mounting Bracket - Manual (Page 4)

Document P/N: 12856-03
Release date: July 2011
E-mail: [email protected]
Web page: www.junipersys.com
Figure 3: Align mounting surface as close as possible to display.
Rotate bracket into position.
4. Rotate the stylus on the mount into place on the Allegro. This will
allow the edge of the small metal bracket to catch the plastic
edge of the stylus receptacle.
5. Hold the stylus firmly in place as you use a thin, narrow, metal
object to work the rubber tabs around the stylus. Do not cut the
rubber tabs.
6. Position the tabs of the larger bracket so that they will go into the
screw holes on the underside of the Allegro.
Figure 4: Position tabs into screw holes (right side shown)
7. Tighten the thumbscrews until the mounting bracket is secure.
Your bracket is now ready for use.
1132 West 1700 North
Logan, Utah, 84321-1723
Phone: 435-753-1881
Fax: 435-753-1896