Casablanca Fan Company Bellatm Bella Ceiling Fan - Manual (Page 8)

7
INSTALL BLADES
Step 10. Using the blade holder screws from
the pack, attach each blade/blade holder as-
sembly to the motor (two screws per blade).
Use the blade access hole to install the
screws.
Using the screwdriver, tighten securely by
hand only.
BLADE HOLDER
SCREW
Step 11. Using the two screws removed
in Step 9, reinstall the blade access plate
to the fan as shown.
Using the screwdriver tighten securely by
hand only.
BLADE ACCESS PLATE INSTALLATION
INSTALL HALOGEN BULB AND GLASS
Step 12. Screw the 100 Watt Halogen bulb into the socket.
Do not touch the glass bulb with your fingers–it is extremely
important that the glass be clean. If it is touched, or dirty,
clean carefully with a tissue. A dirty glass bulb will cause the
bulb to fail almost immediately.
Step 13. Position the indentations in the outer rim of the
glass shade so that they line up with the tabs on the inside
surface of the fan light fixture rim.
Step 14. Carefully lift the glass shade up inside the light
fixture as far as it will go.
Step 15. Rotate the shade in a clockwise direction until it is
held tightly in place by the three tabs.
TABS
GLASS
SHADE
GLASS SHADE
INDENTATION
IMPORTANT! When installing the halogen bulb, care-
fully cut off the end of the plastic sleeve the bulb
comes in and hold the bulb by the plastic sleeve to
screw it into the socket.
HALOGEN BULB
100 WATT
B
ELLA
™