Cobra Electronics CPI 475 - Manual (Page 6)

7 6
Connecting Cables
Mounting •
To mount your inverter:
1. Place the inverter on a flat surface with the mounting
bracket against the mounting surface.
2. Mount to secure surface using mounting hardware
that is corrosion resistant (not included).
The inverter can be mounted horizontally or vertically.
Connecting Cables •
Power wire and wiring are very important to the
performance of the inverter. Because the inverter has a
low voltage, high current input, low resistance wiring is
essential between the battery and inverter. This is so it
can deliver the maximum amount of energy to the load.
Only use the cables provided with your power inverter.
To connect the cables between
the inverter and the battery:
1. Turn the On/Off Switch on the
inverter to the off position. If the
power source is a DC power
supply, switch it off as well.
Installation
Mounting and
Connecting Cables
Installation
Mounting Brackets
Mounting Hardware
2. Connect cable to the Power Input Terminals on
right side panel of the inverter. The red terminal is
positive (+) and the black terminal is negative (-).
Insert the ends of the cables onto the terminals
and tighten the screws to clamp the cables safely.
3. Connect cable to your vehicle’s cigarette lighter socket.
NOTE If the inverter is to be used at levels above
150 watts for extended periods of time, a direct
connection to the battery is recommended. Do
not use the cigarette cord for loads higher than
150 watts. Please contact your local dealer or
customer assistance for the proper cord for
direct to battery connections.
CAUTION Reverse polarity connections (positive
to negative) will blow inverter fuses and may
permanently damage the unit. Such damage
is not covered by the warranty.
CAUTION Remove any jewelry (watch, ring, etc.).
Be careful not to short circuit the battery with any
metallic object (wrench, etc.).
Connect Terminals
Connect Power Source
On/Off Switch to Off
Nothing Comes Close to a Cobra ®
10272-CPI475_PH2.qxd 7/9/07 11:30 AM Page 6