Casablanca Fan Company ISOTOPE C30G45L - Manual (Page 11)

11
I
sotope
®
BladE INSTallaTION
BlADE hARDwARE (not to scale)
Blades (5)
Blade Screws and
Washers (16)
Blade installation
Step 3a. Slide the end of the blade with the three
holes into the slot located on the blade ring. (The
blades will only fit properly over the screws holes
one way. If the holes do not line up, remove the
blade and turn it over). Using three blade screws
and washers, attach the blade to the blade ring,
as shown in Figure #1. Install three screws and
washer one by one using the provided screwdriver.
Tighten securely by hand only. Repeat until all five
blades have been installed on to the fan as shown
in Figure #2.
Phillips
Screwdriver
BLade
WaSheR
BLade
SCReW
(Figure #1)
(Figure #2)