Casablanca Fan Company ISOTOPE C30G45L - Manual (Page 12)

12
lIghT BUlB aNd glaSS INSTallaTION
install halogen Bulbs
Step 4. Screw the two bulbs into the light fixture as
shown in Figure #1.
note: When replacing the bulbs, be sure to use only
50-watt maximum.
haRdWaRe (not to scale)
Glass Shade
50 -watt
halogen Bulbs (2)
iMPoRtant! When installing a halogen
bulb, carefully cut off the end of the plastic
sleeve the bulb comes in and hold the bulb by
the plastic sleeve to screw it into the socket.
GLaSS
Shade
(Figure #1)
(Figure #2)
Glass installation
Step 5a. Align the glass shade up with the bottom of
the fan as shown in Figure #2 and locate the three
glass holding slots. Then locate the three glass hold-
ing tabs, located on the light fixture plate.
Step 5b. Carefully lift the glass globe up inside the
light fixture as far as it will go. Rotate the shade in a
counter clockwise direction as shown in Figure #3,
until the glass globe is held tightly in place by the
three tabs.
GLaSS
hoLdinG
SLotS
GLaSS
hoLdinG
taBS
(Figure #3)