CREATIVE Digital DTT 3500 - Manual (Page 2)

-2
Safety & Regulatory Information
The following sections contain notices for various countries:
Notice for the USA
FCC Part 15: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, this
notice is not a guarantee that interference will not occur
in a particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and
receiver.
• Connect the equipment to an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/ TV
technician.
CAUTION: To comply with the limits for the Class B
digital device, pursuant to Part 15 of the FCC Rules, this
device must be installed with computer equipment
certified to comply with the Class B limits.
All cables used to connect the computer and peripherals
must be shielded and grounded. Operation with non-
certified computers or non-shielded cables may result in
interference to radio or television reception.
Modifications
Any changes or modifications not expressly approved by
the grantee of this device could void the user’s authority
to operate the device.
Notice for Canada
This apparatus complies with the Class B limits for radio
interference as specified in the Canadian Department of
Communications Radio Interference Regulations.
Cet appareil est conforme aux normes de CLASSE “B”
d’interference radio tel que spe’cifie’ par le Ministère
Canadien des Communications dans les règlements
d’interfèrence radio.
Declaration of Conformity
According to the FCC96 208 and ET95-19
Name: Creative Labs Inc.
Address: 1901 McCarthy Boulevard
Milpitas, CA. 95035
United States
Tel: (408) 428-6600
declares under its sole responsibility that the product
Trade Name: Creative Labs/
Cambridge SoundWorks
Model Number: CSW3600
has been tested according to the FCC / CISPR22/85
requirement for Class B devices and found compliant
with the following standards:
EMI/ EMC: ANSI C63.4 1992, FCC Part 15 Subpart B
Complies with Canadian ICES-003 Class B.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1.
This device may not cause harmful interference,
and
2. This device must accept any interference received,
including interference that may cause undesirable
operation.
Ce matériel est conforme à la section 15 des régles FCC.
Son fonctionnement est soumis aux deux conditions
suivantes:
1.
Le matériel ne peut étre source d’interférences et
2. Doit accepter toutes les interférences reques, Y
compris celles pouvant provoquer un
fonctionnement indésirable.
Compliance Manager
Creative Labs, Inc.
August 10, 2000
Compliance
This product conforms to the following Council Directive:
• Directive 89/ 336/ EEC, 92/ 31/ EEC (EMC), 73/ 23/
EEC (LVD)
Important Notice
The serial number for the DTT3500 Digital is located on
the Decoder Amplifier. Please write this number down
and keep it in a secure area. This is for your security.
WARNING: To prevent fire or
shock hazard, do not expose this
appliance to rain or moisture.