CyberData 010861 930106A - Manual (Page 19)

Installing the VoIP Loudspeaker Amplifier
VoIP Loudspeaker Amplifier Operations Guide 930106A CyberData Corporation
13
2.3 Configure the Loudspeaker Amplifier Parameters
To configure the loudspeaker amplifier online, use a standard web browser.
Configure each loudspeaker amplifier and verify its operation before you mount it. When you are
ready to mount a loudspeaker amplifier enclosure, refer to
Chapter 3, “Mounting the Enclosure” for
instructions.
All loudspeaker amplifiers are initially configured with the default IP settings indicated in Table 2-7 .
When configuring more than one loudspeaker amplifier, attach the loudspeaker amplifiers to the
network one at a time to avoid IP address conflicts.
2.3.1 Log in to the Configuration Home Page
1. Open your browser to the speaker IP address.
For the initial configuration of the speaker, open your browser to the default IP address:
http://192.168.3.10
Note Make sure that the PC is on the same IP network as the loudspeaker amplifier.
2. When prompted, use the following default Web Access Username and Web Access Password
to access the Home Page ( Figure 2-9 ):
Web Access Username: admin
Web Access Password: admin
Table 2-7. Factory Default Settings
Parameter Factory Default Setting
IP Addressing static
IP Address 192.168.3.10
Web Access Username admin
Web Access Password admin
Subnet Mask 255.255.255.0
Default Gateway 192.168.3.1