Cannon 300II - Manual (Page 42)

40
■ USER MODE ■
USER MODE
In the user mode, you can arbitrarily change the settings of the
following features:
•
Power saver mode
• Hi-speed scanning mode
• Scanning resolution
• Cleaning mode
• Switching the operation modes (DMP mode/Scanner mode)
User mode setting
1. Press the AE key about 2 seconds.
The LED of the AE key and the Print/Error display blink.
The power saving mode currently set will be displayed on the
Print/Error display.
2. Press the Brightness Adjustment key ( or ) to move the
blinking LED up to the point where a mode, of which settings
you want to change, is located.
Power saver mode
Hi-speed scanning mode
Scanning resolution
Cleaning mode
Switching the operation modes
(DMP mode/Scanner mode)
3. Press the Print Number Setting key ( + or – ) to select the set
ting of each mode.
4. Press the Clear key to difine the setting.
User mode setting functions
Power saver mode
When the MS300II has not been operated for a specified length of
time, the scanner switches into standby mode and stops project-
ing the image on the screen to save power consumption.
: Does not switch into the power saver mode.
: Switches into the power saver mode if not operated more
than 15 minutes. (set at the factory before shipping)
: Switches into the power saver mode if not operated more
than 60 minutes.
MS 300_english.p65 07.5.14, 10:14 40