Cannon 300II - Manual (Page 43)

41
■ USER MODE ■
• Default of the power saver mode at factory shipping
is set to so that the unit switches into the power
saver mode if not operated more than 15 minutes.
• The power saver mode can be canceled by any key
operation.
• When the FS Controller I is attached, the unit can-
not switch into the power saver mode.
Hi-speed scanning
This feature is available in the DMP mode and enables you to
speed up scanning by simplifying the startup operation.
: Normal mode (set at the factory before shipping)
: Hi-speed scanning mode
In the hi-speed scanning mode, the scanner delivers
printouts of the images upside down.
Scanning resolution
When using the DMP mode, you can select one of the following
scanning resolutions.
: 600DPI
: 300DPI (set at the factory before shipping)
Cleaning mode
This mode is enabled when the scanner is connected to the Fileprint
470 and used in the DMP mode so as to clean the fixing rollers of
the printer. (➞ P.45 “Cleaning mode”)
: Normal mode (set at the factory before shipping)
: Cleaning mode (Cleaning paper: A4 sized)
: Cleaning mode (Cleaning paper: Letter sized)
You need to prepare a sheet of paper of the size se-
lected for cleaning and print the cleaning pattern on
the paper before you start cleaning the fixing rollers.
Switching the operation modes
This feature is enabled when the optional DMP board is installed
in the scanner so as to switch to either of the following modes.
: Scanner mode
: DMP mode (set at the factory before shipping)
The MS300II can be used as a scanner even if the
operation mode is set to the [DMP mode]; however,
the Reader-Printer mode will be disabled in this case.
To enable the Reader-Printer mode, be sure to switch
to the [Scanner mode].
MS 300_english.p65 07.5.14, 10:14 41