BMI Racing DB10T - Manual (Page 11)

Install the G10 battery locater with 2 2-56 flat head
screws. The middle position is a good place to
start.
Step 27
Step 28
The Servo mounts are attached to the lower chassis
with two 4-
40 x ¼” flat head screws.
At this time drill out the center holes on your servo
saver (not supplied) for two Nickel Teflon ball studs.
Secure them with two 3/16 alloy lock nuts.
Locate two titanium turnbuckles and four black ball
cups. Assemble them as shown and adjust them to
an over all length of 2.66” (67.5mm). This is a
starting point. You will need to reset their length after
setting your camber in order to achieve the desired
amount of front toe.
Note:
You can use the same plastic bag trick mentioned in
Step 18 to remove play in your steering linkage.
Remember you want to remove play but still have
totally free movement in the links. Any friction at all is
unacceptable and will make you car not center
properly after steering inputs
Install your body posts with two 4- 40 x ½’ flat head
screws in the front (the front bumper fits between the
lower chassis and the front body mounts) and two 4-
40 x ¼” button head screws in the rear.
Step 29