BMI Racing DB10T - Manual (Page 8)

Step 18
3. Apply 10000wt silicon diff oil to the pistons
and insert them into the damper tubes.
4. Attach the alloy pivot balls to the bottom of the
pod top plate and the tops pf the side wings as
shown above. Secure them with alloy lock
nuts
5. Attach a black medium ball stud on top of the
top pod plate in the front and center hole.
Secure it with an alloy lock nut.
6. Attach the carbon pod top plate to the alloy
rear pod plates
7. Snap the ball cups of the assembled damper
tubes onto the pivot balls on the pod top plate
and wings.
Note:
If you feel play between your ball cups and
ball studs, you can place a single layer of
plastic bag material between your ball cup and
ball stud then snap them together. This will
cut and insert a disc of plastic into your ball
cup reducing or eliminating the play. If you
still feel play, repeat the process.
Locate the damper tube parts bag, the rear pod top
plate and 4 4-
40 x ¼” flat head screws..
1. Thread a 4- 40 x ½” set screw into each of the
4 ball cups from the damper parts bag.
2. Thread a ball cup/set screw assembly into the
ends of each of the damper tube pistons and
damper tubes.
Attach 3 7/8” alloy stand offs to the chassis in the
locations shown with 4-
40 x ¼” flat head screws.
Note:
The production stand offs will be black in color not
silver as on the prototype used for these photos.
Install a short ball stud in the battery retention plate
in the hole show in the picture above. Secure it
with an alloy lock nut.
Step 20 Step 19