Connecting ac power to the cisco 10008 router, Go to the – Cisco 10008 User Manual
Page 23
23
Figure 15
Securing DC Power Cables to the Chassis
Step 8
Secure the power cabling to the chassis by feeding a tie wrap through the slot on the safety cover and binding the cables.
Step 9
Replace the rear safety cover, making sure that the power wires exit through the holes on the side of the safety cover.
This completes the installation of the Cisco 10008 chassis in the rack. Go to the
“Connecting Cables” section on page 26
.
Connecting AC Power to the Cisco 10008 Router
The Cisco 10008 router can be powered on directly from the facility VAC input through the AC PEM (100–240 VAC). The AC
PEM is provided with an IEC 320 250V, 20A power cord with a male-type connector (16A rating for Europe) for the attachment
of power cords used throughout the world.
Warning
Only trained and qualified personnel should be allowed to install or replace this equipment. Statement 49
Caution
The 20A connector on the AC PEM is incompatible with the 15A power strips that are used in most equipment
racks. Wiring codes prevent the AC-input power cable from being used with the power strips in equipment racks.
Note
The AC power cord that connects the PEM to the building VAC is not shipped with the Cisco 10008 and must be
ordered separately.
30025