Cisco OL-21851-01 - Manual (Page 15)

5-15
Cisco Unified Communications Manager Configuration Guide for the Cisco TelePresence System
OL-21851-01
Chapter 5 Configuring and Managing the Cisco Unified IP Phone
Configuring the Cisco Unified IP Phone
“More” Softkey Timer — Leave default setting. Revert the soft keys displayed to the initial set after
you touch the more soft key. The valid range of
values for this timer are 5 to 30 -- indicating the
number of seconds before the softkey set reverts. A
value of 0 may also be entered to disable the timer.
Maximum length: 2.
Auto Call Select Yes Enabled. Enables or disables the automatic call focus
switching feature. When “Enabled,” the phone UI
will automatically switch focus to certain calls on
the same line if no user interaction has occurred for
10 seconds. If “Disabled”, the phone UI will not
automatically switch call focus. Disabling the Auto
Call Select feature automatically disables the Auto
Line Select feature.
Log Server — Leave field blank. Specifies an IP address and port of a remote system
where log messages are sent. Maximum length: 32.
Advertise G.722 Codec Yes Use System Default. Indicates whether Cisco Unified IP Phones will
advertise the G.722 codec to Cisco Unified
Communications Manager. Codec negotiation
involves two steps:
1. The phone must advertise the supported
codec(s) to Cisco Unified Communications
Manager (not all endpoints support the same set
of codecs).
2. When Cisco Unified Communications Manager
gets the list of supported codecs from all phones
involved in the call attempt, it chooses a
commonly-supported codec based on various
factors, including the region pair setting.
Valid values specify Use System Default (this phone
will defer to the setting specified in the enterprise
parameter, Advertise G.722 Codec), Disabled (this
phone will not advertise G.722 to Cisco Unified
Communications Manager) or Enabled (this phone
will advertise G.722 to Cisco Unified
Communications Manager).
Wideband Headset UI
Control Yes Enabled. Users can enable or disable Wideband Headset
option on phone user interface (UI).
Wideband Headset Yes Enabled. Enables or disables the use of a Wideband Headset
on the phone. Used in conjunction with User Control
Wideband Headset.
Table 5-9 Product Specific Configuration Layout Fields (continued)
Field Required? Setting Description