CITIZEN CL-S700 - Manual (Page 45)

45
Printer Operation
Top Menu Sub Menu Default Menu Remarks
Rewinder Auto Off On [CL-S700R only]
Online*** Off Sets the Rewinder Auto Online.
[Rew Auto Online] In the case in which the setting is On, when
the Rewinder Open Error occurs, if the
Rewinder Cover is closed, it will automatically
return to Online and printing will restart.
Rewinder Online 2 sec 1 to 10 sec [CL-S700R only]
Delay*** Sets the Rewinder Online Delay.
[Rew OnlineDelay] Sets the time until the Rewinder restarts after
the Rewinder Cover is closed when the above
Rewinder Auto Online is On.
Rewinder Torque*** 4 1 to 7 [CL-S700R only]
Sets the Rewinder Torque.
Peel Wait Delay** 0.1 sec 0.1 to 2.0 sec Sets the Peel Wait Delay.
Displays only machines with a peeler
installed.
Paper Position 0.00 inch Peel/Cut/Tear Off Adjusts the stop position. It is based on the
0.00 mm 0.00 to 2.00 inch inch/millimeter setting. There are initial
0.0 to 50.8 mm values of the stop position for each device
Peel/Cut/Tear On set above, and later, relative values are set.
-1.00 to 1.00 inch
-25.4 to 25.4 mm
Menu Key Action Enters Menu Enters Menu Sets the menu key action.
Repeat Last Set Enters Menu:
Repeat Last One Enters the menu setup mode.
Repeat Last Set:
Repeats the number of copies.
Repeat Last One:
Last one is issued only for the final page.
In the case of a count, afterwards, only
last one is issued.
Note: Hold down the MENU key for at least 4
seconds in order to enter the Menu Setup
Mode when setting the “Repeat Last Set” or
“Repeat Last One” menus.
Interfaces RS-232C Baud 9600 115200 Setting the baud rate of the serial interface.
57600 • All settings related to the interface are
38400 enabled after the power is reconnected.
19200
9600
4800
2400
RS-232C Parity None None Setting the communication parity for the
Odd serial interface.
Even
RS-232C Length 8 bits 8 bits Setting the character length for the serial
7 bits interface.
RS-232C Stop bit 1 bit 1 bit Setting the stop bit for the serial interface.
[RS-232C Stopbit] 2 bits
RS-232C X-ON On Yes On Yes Selectively setting the X-ON flow control of
Off No the serial interface.
IEEE1284 On On Setting both direction of the Centro
Off Interface.
USB Device Class Printer Printer Selects the USB device class.
[USB Device Clas] VCOM
Mode Settings
[Datamax ® Emulation]
** Only when cutter is mounted.
*** Only the Rewinder.