Programming, To add or reprogram a hand-held remote control, Using the “learn” button – Chamberlain 248754 User Manual

Page 37: Using the motion detecting door control console, To erase all codes from motor unit memory, Button remotes, Button remotes (315 mhz)

Advertising
background image

37

PROGRAMMING

*3-Button Remotes (315 MHz)

If provided with your garage door opener, the large button
is factory programmed to operate it. Additional buttons on
any Security

®

3-button

remote or mini-remote can
be programmed to operate
other Security

®

garage

door openers.

To Erase All Codes From Motor

Unit Memory

To deactivate any unwanted remote, first erase all codes:

Press and hold the “learn” button on
motor unit until the learn indicator light
goes out (approximately 6 seconds). All
previous codes are now erased.
Reprogram each remote or keyless
entry you wish to use.

1. Press and hold the button on the

hand-held remote

*

that you wish to

operate your garage door.

2. While holding the remote button, press

and hold the LIGHT button on the
Motion Detecting Door Control.

3. Continue holding both buttons while

you press the push bar on the Motion
Detecting Door Control (all three
buttons are held).

4. Release buttons when the motor unit

lights blink. It has learned the code. If
light bulbs are not installed, two clicks
will be heard.

1. Press and release the “learn” button

on the motor unit. The learn indicator
light will glow steadily for 30 seconds.

2. Within 30 seconds, press and hold the

button on the hand-held remote

*

that

you wish to operate your garage door.

3. Release the button when the motor

unit lights blink. It has learned the
code. If light bulbs are not installed,
two clicks will be heard.

LOCK

LIGHT

LOCK

LIGHT

NOTICE: If this Security

®

garage door opener is operated with a non-rolling code remote control, the technical

measure in the receiver of the garage door opener, which provides security against code-theft devices, will be
circumvented. The owner of the copyright in the garage door opener does not authorize the purchaser or supplier of the
non-rolling code remote control to circumvent that technical measure.

Your garage door opener has already been programmed at the factory to operate with your hand-held remote control.
The door will open and close when you press the large push button.

Below are instructions for programming your opener to operate with additional 315 MHz Security

®

remote controls.

To Add or Reprogram a Hand-held Remote Control

USING THE “LEARN” BUTTON

USING THE MOTION DETECTING DOOR CONTROL
CONSOLE

Advertising